Automatic plaster bandage winder
ANB-12
Automatic bandage winder has 3 outlets, each of them can work with a different bandage width. There is a possibility of selective disconnecting of individual outlets.
The machine is equipped with:
- microprocessor control system
- electronic drive control system with an inverter
- pneumatic operating systems
The following tasks are fully automatic:
- initial trapping of the bandage end
- stopping of the process when a programmed bandage length is wound
- cutting of the bandage
- slipping the bandage roll off the spindle
- transfer of the bandage roll into a container
Operating the machine means only putting bandage into winding spindles and collecting the containers loaded with produced bandage rolls.
Control systems guarantee:
- stopping of the machine in case of lack of the bandage in the outlets
- stopping of the machine when a programmed number of rolls is wound
- stopping of the machine in case of a pressure drop below the value required by the pneumatic system
- synchronization work machine with machine for packing
The design of the machine guarantees:
- high productivity
- the same length of the wound bandage in all of the outlets
- high quality of the bandage rolls
- winding of the bandage 60, 80, 100, 120, 150, 200mm wide
- completing the process in case of mains voltage drop
Use of the device
The machine is used for rewinding plaster bandage from big bobbins into smaller bandage rolls used in trade practices.
All the manual work except for replacing the bobbins is done automatically. The machine is designed to cooperate with packaging machine which packs the produces rolls.
- inner cylinder diameter
60; 80; 100; 120; 150; 200
60; 80; 100; 120; 150; 200
Length of the bandage in a roll
Bandage roll diameter max.
Exemplary productivity for the rolls 3m long (3 outlets)
Overall dimensions for 3 outlets machine (length x width x height)
Pressure of the pneumatic system
Approximate air consumption
Noise level in the place of work